Back to Cross index | REQUEST PRODUCT INFORMATION! | |
2009-59H 5.925 to 6.425 GHz Test Downconverter |
||
The 2009-59H Test Downconverter converts a high power (+15 dBm max) 5.925 - 6.425 GHz signal to 950 - 1450 MHz with a high side, high stability (± 4 ppm), low phase noise, local oscillator (LO) (inverted spectrum). Operating over an extended -20 to +60 deg. C temperature range, this unit is used to downconvert “clean” (only this frequency) 5.925 - 6.425 GHz signals to 950 - 1450 MHz for test purposes. The 5.925 - 6.425 GHz is mixed with a synthesized LO to a 950 - 1450 MHz signal which goes to the output attenuator providing a nominal -40 dB gain. Connectors are 75 ohm F female for the 950 - 1450 MHz output and 50 ohm N, female for the RF input. Front panel LEDs show DC power is applied (green) and if a PLL alarm occurs (red). DC power is provided by the LNB voltage from the receiver under test or by an external wall mount power supply (option -P, 115 VAC or Option -P4, 90-260 VAC). Option -C has no power supply and is powered by an external power supply like the 2000-01. The 2009 can be mounted on an 1 3/4” X 19 “ rack mount panel (option -R). |
2009-59H Test Downconverter Block
Diagram
Equipment Specifications*
Input Characteristics | |
Impedance/RL Frequency Level, max Input 1dB compression |
50 ohms/10dB 5.925 to 6.425 GHz -20 to +15 dBm +20 dBm |
Output Characteristics | |
Impedance/RL Frequency |
75 ohms/10dB 950 to 1450 MHz |
Channel Characteristics | |
Gain
at band left Spurious Response Frequency Response |
-40dB ±2dB < -40dBC, 950-1450 MHz out ±2dB, 950-1450 MHz; ±0.5dB, any 10 MHz incr. |
Synthesizer Characteristics | |
Frequency Accuracy Phase Noise (dBC/Hz) |
±4ppm max <= -85, 1kHz; <= -90, 10kHz; <= -95, 100kHz; <= -110, 1MHz |
Indicators | |
DC
Power Alarm |
Green LED Red LED |
Other | |
RF IN
Connectors RF OUT Connectors Size, Bench Top Size, Rack Mount (-R) Power AC Power (-P) |
Type N, female Type F, female 4.7"W X 1.75"H X 6.5"D 19 inch standard chassis, 1.75"H X 7"D (optional) +16 to +20 VDC, 250 ma on RF Out 120 ± 10% VAC, 60Hz, 15W max, wall mount power supply |
Models | |
2009-59H 2009-59HC 2009-59HP 2009-59HP4 |
5.925-6.425 GHz
in, 950-1450 MHz out, Uses Rcvr LNB Voltage 5.925-6.425 GHz in, 950-1450 MHz out, No Pwr Supply (use with 2000-01 Pwr Supply) 5.925-6.425 GHz in, 950-1450 MHz out, 115 VAC Wall Power Supply 5.925-6.425 GHz in, 950-1450 MHz out, 90 - 260 VAC Wall Power Supply |
*-20 to +60 degrees C; 2000m max elevation; 80% humidity; Specifications subject to change without notice